Publicidad
2
5
30
1
3
4
6
7
English
TO REMOVE/REPLACE NECKROLL
First remove the cheek pads as per previous instructions. Next, pull out the
neckroll end tabs, which are inserted into the chin centerpad at both sides(1).
To remove the neckroll, grasp center of the neckroll firmly (2), rotate it to either
direction by 3cm - 4cm (1-1/4" – 1 – 1/2") (3) and remove it from the helmet
(4).
To wash the neckroll, put them into lukewarm water with small amount of
laundry soap or your own shampoo and wash gently by hand. Rinse well with
fresh water and wipe off with a soft cloth. Dry them in the shade at ambient
temperature. Do not machine wash or dry.
WARNING:
Never use petrol, thinner, benzene or any other solvents. Even mild and seemingly
harmless chemicals can cause damage over a short period of time.
To replace the neckroll, center and insert the neckroll frame into the slot
between the shell and EPS liner of the helmet. Locate the two tabs on the frame
and press both down until both are locked in the slot of the helmet.
Replace the neckroll end tabs (7), and replace the cheek pads.
Publicidad
