Publicidad
1
4
English
TO OPEN/CLOSE SHIELD
Pull the shield latch tab on lower left side of the shield outward to release
2
the latch system
To close the shield, push down the shield until the shield latch tab fully
3
latches into place (3).
Apply one or two drops of supplied silicone lubricant around the edge trim
and on other moving parts and wipe off with soft tissue paper to maintain
proper operation.
WARNING:
If your shield becomes too scratched or uncleanable, replace it with a new
one. Impaired visibility causes accidents.
Use a solution of mild soap or detergent and lukewarm water to clean your
shield. Rinse well with clean water, and wipe off with a soft cloth. Never use
petrol, thinner, benzene or any other solvents. There are many "aggressive"
cleaners on the market, including some supposed to be specifically for use
on shields. Arai strongly recommends that you do not use any such products
to clean your shield as some of their ingredients may have damaging effects
on the shield and other plastic parts installed on your helmet.
Do not apply stickers or adhesive tape to the shield, as this will weaken the
hard coating. Tinted or mirrorized shield is for daylight use or in high visibility
conditions only. Never use tinted or mirrorized shield at night or in poor
visibility conditions.
and then raise the shield (2).
(1)
Publicidad
