Publicidad
6
TO REMOVE/REPLACE BREATH DEFLECTOR
To remove, grasp either side of the edge and pull upward and toward to
1
opposite end
To install, first insert the center of the deflector in the receiving slot and then
2
push in the sides working from the center outwards
TO ADJUST PEAK ANGLE
Slightly loosen the screw from each side of the peak with a flat blade
screwdriver or small coin so that the peak can be moved up and down easily.
Adjust the peak to the desired position. Tighten the screws firmly but do not
over-tighten. Do not adjust the peak with the screws tightened, always loosen
the screws for adjustment.
English
(1)
.
(2)
.
Publicidad
