Publicidad
Idiomas disponibles
Idiomas disponibles
After the product has been fully configured,
a restart is required.
u Click the "Restart" button to restart the
product.
6.7.2 View status information
Status information about the product is displayed in
the "Dashboard" menu, e.g.
n Current state
n Fault messages
n Charging processes
n IP address (parameter "Interfaces")
n ...
n Configuration settings made
n Load management
n Connection of an external energy meter
n ...
6.8
Setting the maximum charging current
The tasks described in this section may only
be carried out by a qualified electrician.
u Navigate to the menu "Installation" > "General
Installation" and set the following parameters:
Left-hand charging point
Parameter
Installation Current
Limit [A]
Right-hand charging point
Parameter
Installation Current
Limit [A] (Connector 2)
u Click the "Save" button to save the setting(s).
6.9
Integrating the product into a local
network
The tasks described in this section may only
be carried out by a qualified electrician.
Setting
u Enter the maximum
charging current [A].
Setting
u Enter the maximum
charging current [A].
u Connect the central router / switch and the
USB-Ethernet adapter with an Ethernet cable.
The product is configured as a DHCP client on de-
livery. After the product has been connected to the
router / switch, the IP address is assigned to the
product dynamically by the router.
If necessary, a static IP address can be assigned to
the product in the web interface.
u Navigate to the menu "Network" > "LAN" and
set the following parameters:
Parameter
Show LAN Configura-
tion
Mode for ethernet con-
figuration
Static network configur-
ation IP
Static network configur-
ation netmask
A detailed description of networking, the
connection to a backend system and load
management, including application ex-
amples, can be found on our website in the
download section for the selected product.
1 "1.1 Website" [
6.10 Setting operating modes
The tasks described in this section may only
be carried out by a qualified electrician.
6.10.1 "Standalone Autostart" operating mode
The product is operated as a stand-alone solution
without connection to a backend system. Charging
starts automatically as soon as the vehicle is
plugged in.
u Navigate to the menu "Backend" > "Connec-
tion" and set the following parameters:
Setting
u Select "Show".
u Select "Static".
u Enter static IP ad-
dress.
u Enter network
screen.
3]
}
EN
27
Publicidad
