Publicidad
Idiomas disponibles
Idiomas disponibles
Information on compatible energy manage-
ment systems and the description of the EE-
Bus interface (EEBus Register Table) can be
found on our website:
www.mennekes.org/emobility/knowledge/
compatible-systems-and-interfaces
u Navigate to the menu "Load Management" >
"EEBUS interface" and set the following para-
meters:
Parameter
Setting
EEBUS inter-
u Select "On".
face
Current in case
Current value for charging if
of connection
there is no connection to the en-
failure [A]
ergy management system.
Communica-
Period between disconnection
tion Timeout [s]
from the energy management
system and charging with fall-
back current.
Connect or dis-
n Connect to energy manager:
connect the
The product can connect to
energy man-
the energy management sys-
ager
tem.
n Disconnect energy manager:
The product disconnects from
an existing connection to the
energy management system.
6.11.5 Setting Autocharge
The tasks described in this section may only
be carried out by a qualified electrician.
Only valid for the PnC-compatible product variants.
With Autocharge, authorisation takes place auto-
matically by means of a unique vehicle ID (e.g. the
vehicle's MAC address).
34
n Autocharge is not the same as Plug and
Charge according to ISO 15118, in which
the authorisation takes place by means
of a contract certificate from the eMobil-
ity Service Provider (EMP), which must be
stored in the vehicle.
n Autocharge is not an official or standard-
ised function of the automobile or char-
ging infrastructure manufacturers.
n MENNEKES cannot guarantee that
Autocharge will always function
properly with the vehicles in the list
below. Compatibility with
Autocharge can vary, including de-
pending on the model and software
version of the vehicle. The list results
from various field tests with the lis-
ted vehicles.
n Autocharge is currently of an experi-
mental nature and will be optimised
and improved in the next firmware
versions.
Requirement(s):
ü For connection to a backend system: The
backend system supports Autocharge.
ü The vehicle can transmit a unique vehicle ID.
You can find a list of the vehicles in which
Autocharge was successfully tested by
MENNEKES on our website at:
www.mennekes.org/emobility/services/
autocharge
The vehicle ID is treated in the same way as an
RFID UID.
u Navigate to the menu "Authorization" > "HLC
15118" and set the following parameters:
Parameter
Setting
Autocharge
u Select "On".
Publicidad
