Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
WARNING: Before it is put into servi-
ce, the system must be tested to check the
operating conditions of every single compo-
nent and identify any malfunctions. In this
stage, it is important to check that all health
and safety requirements have been com-
plied with in full.
To test the system, make the following checks:
ATurn on the gas supply tap and check that
1)
the connections are right.
Check that the mains gas is the same as that
2)
used for commissioning of the appliance,
and carry out the conversion procedure if
necessary (see page12).
INSTRUCTIONS AND WARNING FOR ADJUSTMENTS
WARNING: Before making any type
of adjustment, activate all the safety devic-
es provided and decide whether staff at work
and those in the vicinity should be informed.
In particular, turn off the gas and water sup-
ply taps, cut off the electricity supply us-
ing the master switch and prevent access to
all devices which might cause unexpected
health and safety hazards if turned on.
14
TESTING OF THE APPLIANCE
3)
4)
5)
6)
After testing, if necessary instruct the user in all
the skills necessary for putting the appliance
into operation in conditions of safety, in ac-
cordance with legal requirements.
ADJUSTMENTS
quired if the type of gas to be connected is
diff erent from that used for testing after the
conversion procedure has been carried out
(see page 13).
ried out by authorised, qualifi ed staff , in ac-
cordance with the relevant legal require-
ments.
Check that the burner is switching on cor-
rectly and its combustion.
Check the gas pressure and fl ow-rate at mini-
mum and maximum settings and adjust if
necessary (see page 15).
Check that there are no gas leaks.
Check that the nameplates specify the cor-
rect gas for the country of use.
NOTE: This adjustment is only re-
WARNING: Adjustments must be car-
3269860_inst_GB_rev.2
ADJUSTMENTS
Publicidad
