Angelo Po 0N1FR1I Manual De Uso página 32

ENGLISH
HAZARDS AND SAFETY PROVISIONS DURING ASSEMBLY
When assembling the appliance, watch out for the following hazards and provide for the
countermeasures indicated below:
► Source of hazard: Handling of heavy loads
Where or in which situations
Hazard
does the hazard occur?
Risk of injury due
to body overload
HAZARDS AND SAFETY PROVISIONS DURING INSTALLATION AND
COMMISSIONING, ADJUSTMENTS AND PART REPLACEMENT
During appliance installation, commissioning, adjustment and part replacement procedures,
watch out for the following hazards and provide for the countermeasures indicated below.
► Source of hazard: appliance mechanics
Hazard
Risk of crushing
parts of the body
in case of tip-
over or fall of the
appliance
Risk of cutting due
to sharp edges
Risk of crushing
parts of the body
in case of fall of the
appliance
6
• When the appliance
moves
Where or in which situations
does the hazard occur?
When the appliance is lifted • Pay attention to the centre
When handling sheet-metal
parts
In case of uneven or sloped
fl oors
Countermeasures
• Use a suitable lifting devi-
ce to place the appliance
on the work bench, on the
base
• Adjust the position only if
a suitable number of peo-
ple is available, otherwise
observe the limit values
for lifting and transport
• Comply with the applica-
ble laws on accident pre-
vention for the installation
place
• Wear personal protective
equipment
Countermeasures
of gravity
• Avoid collisions
• Pay special care during
this activity
• Wear personal protective
equipment in accordance
with safety regulations
• Comply with the correct
installation requirements
as per section Installing
the appliance on page 10
of the installation manual.
SAFETY
Safety device
• Protective
gloves
• Protective
shoes
• Safety hel-
met (e.g. for
suspended
loads, overhead
operations...)
Safety
device
None
None
None
3269860_ut_GB_rev.2