Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING GUIDE
PROBLEM
Espresso
Machine turns
itself off
Grinder will not
operate after a
large amount of
grinding, and
grind icon is
flashing
Machine beeps
and Grinder Icon
flashes when
trying to use the
grinder
Not possible to
pour espresso
and dispense
hot water at the
same time
Not all lights
illuminate when
the unit is
switched on
Dispensed
quantity of grinds
is too much or
too little
BVSTEM7400_23SEM1 (LA)_SPA/ENG.indd 17
BVSTEM7400_23SEM1 (LA)_SPA/ENG.indd 17
Possible cause
Your Espresso machine will go into Standby
mode after 20 minutes to conserve power.
Your grinder has overheated.
Rapid icon flashing, and 3 beeps - grinder
has overheated.
Slower icon flashing and beeping for 3
seconds- bean hopper is not correctly
installed.
Initially the dual thermoblock heater
functionality allows simultaneous dispense
of either espresso or hot water, at the same
time as steam.
When switched on initially the unit will
enter a warm-up mode, during this time the
power-on light will pulse.
The factory grinder settings do not match
your personal preferences.
A double grind shot was selected instead of
a single.
English - 17
What to do
Flick on/off power switch downwards to reactivate
your machine.
Wait for 6 minutes, once the auto-cool down
cycle has finished your machine will be ready
to use again.
Wait for 6 minutes, once the auto-cool down
cycle has finished your machine will be ready
to use again.
Correctly install the Bean Hopper.
Finish brewing your espresso before adding
hot water.
Wait until the unit is warmed up, the power light
will stop pulsing, and the display will illuminate.
The grinder can be stopped at any time during the
grinding process by tapping once downwards on
the portafilter handle if over dispensing.
If the grind dispense amount is too small, the
quantity of grinds in the portafilter can be topped
up by pushing down on the portafilter handle to
manually activate the grinder. Release the handle
when grind amount is correct.
The grinder dispense volume can be customised
to your requirements, see 'Fine tuning your
espresso' section.
Ensure that '1' is displayed on the Grind Setting
Position (1C).
2023/11/7 10:38
2023/11/7 10:38
Publicidad
