Publicidad
Idiomas disponibles
Idiomas disponibles
CARE AND CLEANING – GRINDER
- Reset to the Grind Setting noted prior to cleaning.
Cleaning & Unblocking Grinder Burrs, Collar,
Grind Chamber and Outlet
• 1-2 Months
If the Grinder is used frequently (everyday),
the Burrs need to be cleaned to ensure best
performance of the integrated Grinder. Regular
cleaning helps the Burrs achieve consistent grinding
results, which is especially important when grinding
coffee beans for espresso.
• Grind Off Excess Coffee Beans
- The machine is on and in the READY state.
- Make note of the current Grind Setting (to use as
the starting point after cleaning).
- Insert Two Cup Filter Basket into the Portafilter.
- Insert Portafilter into Grinding Cradle.
TWO CUP
- Turn Bean Hopper fully anti-clockwise to close the
Hopper Gates and unlock the Bean Hopper. The
Bean Hopper will pop up slightly.
- Remove the Portafilter and dispose of the waste
grinds as these will be too coarse for espresso
coffee.
- Remove the Bean Hopper from the Grinder Collar
and store any remaining coffee beans in an airtight
container to preserve their freshness.
BVSTEM7400_23SEM1 (LA)_SPA/ENG.indd 32
BVSTEM7400_23SEM1 (LA)_SPA/ENG.indd 32
- Reinstall the bean hopper and rotate to setting
30. Push down on the portafilter to activate the
grinder, and hold the remain beans are ground
and dispensed (you will hear the sound of the
motor change).
- Rotate and remove the bean hopper again
- Remove the Portafilter and dispose of the waste
grinds as these will be too coarse for espresso
coffee.
2. REMOVE
1. TURN
• Preparing to Clean
- Turn off the machine, switch off & unplug at power
outlet.
CAUTION: Care should be taken when cleaning
Grinder Burrs as they are sharp.
• Cleaning Top Burr
- Rotate to unlock and lift the Top Burr from the
Grinder Collar using the handle.
- Wash the Top Burr in warm soapy water with a
mild detergent, rinse & dry.
English - 32
AIR TIGHT
CONTAINER
2023/11/7 10:38
2023/11/7 10:38
Publicidad
