Look X-Track Power Manual Del Usuario página 18

EN
03
Add your power sensor.
In the application, add your power sensor to your
product ecosystem.
To know :
After their initial activation, LOOK POWER
pedals automatically switch to 'light' sleep mode
after 5 minutes of inactivity. They will turn on
automatically when they detect any movement,
such as crank rotation, for example.
To know :
You can switch the pedals back to 'deep
sleep' mode in the 'Expert mode' tab using the
application (refer to the paragraph on Expert
mode.
04
Pedal installation.
When you receive your LOOK POWER pedals,
they are delivered in 'deep sleep' mode to conserve
battery.
A/ Charge them for a few seconds to wake them up
until they blink.
It is recommended to do a full charge of your pedals
before the first use. A full charge takes approximately
2 hours.
Enabled Disabled
Deep sleep
Via the While charging
appication the pedal
Light sleep
After 5 minutes Upon detec-
of inactivity ting movement
B / Before installing the pedals on the crank arms,
lightly grease the pedal threads. This will make
tightening more effective and facilitate their removal.
C / Tighten the pedals to a torque between 30 and
40 Nm.
To know :
30 Nm is equivalent to a force of 15 kg applied
with a lever of 20 cm (the size of a non-
professional pedal wrench).
The tightening of the pedals is done:
- Clockwise (facing the pedal) for the right pedal.
- Counterclockwise (facing the pedal) for the left
pedal.
Serrage
Serrage
D / After installing the pedals, place the chain on
the largest chainring and the smallest cog of the
cassette.
Ensure that the plastic cap of the right pedal does
not touch the chain, neither at the top nor at the
bottom. A distance of 1.5 mm between the chain and
the pedal antenna is recommended.
RIGHT If necessary, you can add a 1 mm spacer between
the pedal and the crank arm (spacers are included
in the box).
LEFT
EN
>1.5 mm