Look X-Track Power Manual Del Usuario página 26

EN
X-Track Power
A
29010
LEFT INSTRUMENTED POWER AXLE
29009
RIGHT INSTRUMENTED POWER AXLE
29011
RIGHT NON INSTRUMENTED POWER AXLE
29017
X-TRACK POWER LEFT BODY
29018
X-TRACK POWER RIGHT BODY
29020
POWER BEARINGS REFRESH KIT
29021
POWER CHARGER
29022
Y USB C CABLE
29073
POWER ENDCAP REMOVING TOOL
B
C
D
E
1 x INSTRUMENTED AXLE / 1 x INTERNAL DUAL LEAP SEAL
1 x INSTRUMENTED AXLE / 1 x INTERNAL DUAL LEAP SEAL
1 x NON INSTRUMENTED AXLE / 1 x INTERNAL DUAL LEAP SEAL
1 x BODY / 1 x LEVER / 1 x BLADE / 1 x END CAP / 1 x NEEDLE BEARING / 1 x SEALED
CARTRIDGE BEARING / 1 x DUAL LEAP SEAL (INTERNAL & EXTERNAL) / 1 X SPINDLE
SCREW
1 x BODY / 1 x LEVER / 1 x BLADE / 1 x END CAP / 1 x NEEDLE BEARING / 1 x SEALED
CARTRIDGE BEARING / 1 x DUAL LEAP SEAL (INTERNAL & EXTERNAL) / 1 X SPINDLE
SCREW
2 x NEEDLE BEARING / 2 x SEALED CARTRIDGE BEARING / 1 X SPINDLE SCREW LEFT /
1 X SPINDLE SCREW RIGHT
1 x CHARGER
1 x CABLE USB C Y
1 x REMOVAL TOOL
Legal guarantee:
Through its approved agents and distributors in the
country in which the product has been purchased,
LOOK guarantees its bikes/frames
nonconformities and hidden defects (1) for a period
of five (2) years counting from the date of purchase.
(1) Hidden defects are covered by French legislation
only. § 1641 to 1649 of the civil code.
DECLARATION OF CONFORMIITY
FCC compliance statement
The enclosed hardware device complies with part
15 of the FCC.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and
(2) it must accept any interference received,
including interference that may cause undesired
operation.
This equipment has been tested and found to
comply with limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against
harmful interference in residential installations. This
equipment generates, uses, and can radiate Radio
frequency energy, and if not installed and used
in accordance with the instructions, may cause
harmful interference to Radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause interference to Radio or
television equipment reception, which can be
determined by turning the equipment off and on, the
user is encouraged to try to correct the interference
by one or more of the following measures:
WARRANTY
(2) Certain countries or states authorise a higher
limitation of duration for an implicit guarantee,
and/or for exclusion or limitation of direct or
consequential damages, which implies that the limit
against
is not applicable in this case. This limited guarantee
grants you specific legal rights, but possibly also
other rights, which will vary according to local
legislation.
1/ Reorient or relocate the receiving antenna.
2/ Increase the separation between the equipment
and receiver.
3/ Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
4/ Consult the dealer or an experienced Radio/TV
technician for help.
To assure continued compliance, any changes or
modifications not expressly approved by the party
responsible for compliance could void the user's
authority to operate this equipment. (Example- use
only shielded interface cables when connecting to a
computer or peripheral devices).
Caution! The manufacturer is not responsible
for any Radio or TV interference caused by
unauthorized modifications to this equipment. Such
modifications could void the users' authority to
operate the equipment.
EN