Roger Technology B70/1T Instrucciones Y Advertencias Para El Instalador página 60

8
Display function modes
8.1
Parameter display mode
PARAMETER
PARAMETER
See chapter 12 for detailed descriptions of the parameters.
8.2
Command and safety device status display mode
COMMAND STATUS
AP PED
PP
CH ORO
POWER
COMMAND STATUS:
The command status indicators on the display are normally OFF.
They ILLUMINATE when a command is received (e.g.: when a step mode command is received, the segment PP
illuminates).
SEGMENT COMMAND
open
step-by-step mode
close
partial opening
clock
SAFETY DEVICE STATUS:
The safety device status indicators ON the display .
If an indicator is OFF, the relative device is in alarm state or is not connected.
SEGMENT SAFETY
FT1 photocells
FT2 photocells
COS1 sensing edge
COS2 sensing edge
gate open limit switch
gate closed limit switch
release pin rotated
60
VALUE
SAFETY DEVICE STATUS
FT1
COS1
COS2
SB STOP
FT2