Roger Technology B70/1T Instrucciones Y Advertencias Para El Instalador página 72

Limit switch enabling
Limit switches disabled; programming the stroke and repositioning causes the sash to press on the mechanical stops,
par. and
Limit switches enabled; stroke programming and repositioning are managed by the activation of the magnetic opening
and closing limit switches.
Setting motor stop distance
Selecting installation position of motor relative to gate (seen from interior side)
N.B.: in the event of a reset to restore the default parameters, this parameter must be set again manually.
Motor installed on left.
Motor installed on right.
Sensing edge NOT INSTALLED.
NC contact (normally closed). The gate reverses only when opening.
Contact with 8k2 resistor. The gate reverses only when opening.
NC contact (normally closed). The gate always reverses.
Contact with 8k2 resistor. The gate always reverses.
Management of two 8k2 sensitive edges connected in parallel (total resistance 4k1). The gate reverses only when opening.
Management of two 8k2 sensitive edges connected in parallel (total resistance 4k1). The gate always reverses.
Sensing edge NOT INSTALLED.
NC contact (normally closed). The gate reverses only when closing.
Contact with 8k2 resistor. The gate reverses only when closing.
NC contact (normally closed). The gate always reverses.
Contact with 8k2 resistor. The gate always reverses.
Management of two 8k2 sensitive edges connected in parallel (total resistance 4k1). The gate reverses only when closing.
Management of two 8k2 sensitive edges connected in parallel (total resistance 4k1). The gate always reverses.
STEP MODE.
PARTIAL OPENING
OPENING
CLOSING.
STOP.
Courtesy light. The output COR is managed from the remote control. The light remains lit as long as the remote control
is active. The parameter
Courtesy light in step mode (PP). The output COR is managed from the remote control.
The remote control turns the courtesy light on and off. The parameter
(1)
enable the command. Example: parameters
•
seconds by pressing CHB on the remote control. Press CHB to activate partial opening.
72
adjust the stopping distance from these.
COS1
COS2
is ignored.
(1)
(1)
(1)
and
N.B.: With ROGER TECHNOLOGY plug-in radio receiver board.
N.B.: With ROGER TECHNOLOGY plug-in radio receiver board.
is ignored.
(1)
set: