Publicidad
Idiomas disponibles
Idiomas disponibles
at the opposite limit switch takes place at the reduced speed set automatically (irrespective of the settings of
parameters
,
and
• If, on the other hand, the leaf is in an intermediate position, it runs at reduced speed and the activation of one of the
two limit switches allows immediate recovery of the position.
Without limit switch (
The execution of a complete stroke, from one mechanical stop to the other, allows the position to be recovered. The
leaf retracts by the number of revolutions chosen in paragraphs
• Only for TW90/800/R - TW90/820/R motor. If the control unit detects a manual movement of more than 3 cm from
the initial position, it launches a movement command that returns the sash to the position.
20
Initial testing
The installer is required to measure impact forces and select on the control unit the appropriate speed and
and EN 12445.
Make sure that the provisions in "GENERIC WARNINGS" are observed.
• Turn on the power supply.
• Check that all connected controls are working correctly.
• Check that the release pin works correctly. The message
• Check travel and deceleration.
• Check that the impact force is correct, in compliance with EN 12453 and EN12445.
• Check that the safety devices are activated correctly.
• If the battery kit is installed, disconnect from mains and check that the batteries are working.
• Disconnect from mains power and disconnect the batteries (if used), then reconnect. Starting with the gate stopped
in an intermediate position, check that the position recovery procedure is completed correctly for both the open and
closed positions.
• Check that the limit switches are set correctly and function correctly (if installed). If necessary, change the setting
of the parameter determining the motor position (right, left).
• Check that there is a gap of at least 2-3 cm between the gate and the mechanical stop at the end of the manoeuvre.
• Only for TW90/800/R - TW90/820/R. Check that without mains or battery voltage, when moving the leaf by hand,
the control unit is switched on and that the display shows the "
• Only for TW90/800/R - TW90/820/R. If there are batteries, disconnect the mains power and check that the display
shows
. If
is displayed followed by
Declaration CE of Conformity
The undersigned Dino Florian, legal representative of Roger Technology - Via Botticelli 8, 31021 Mogliano V.to (TV)
DECLARES that the B70/1T digital control unit is compliant with the provisions established by Community directives:
EN 61000-6-3
EN IEC 61000-6-2
EN 60335-1
), recovering position control with maximum precision.
)
,
.
" message.
, change the red and black cables connection to the POWER-IN
83
Publicidad
