Publicidad
Idiomas disponibles
Idiomas disponibles
OPT STEP 2
3.
turn the wheel until the valve gets to 6 o'clock position (the bottom arrow turns from
red to green);
4.
make a chalk mark on the tyre external side at 12 o'clock;
5.
confirm you marked the tyre by selecting Enter
6.
remove the wheel from the wheel balancer;
7.
turn the tyre on the rim until the mark made matches the valve (180º rotation);
8.
refit the wheel on the wheel balancer and confirm the operation described in points
6 and 7 by pressing the Enter button
Then, following the new indications on the monitor:
9.
turn the wheel until the valve gets to 12 o'clock position;
10. press the Enter button
11. perform a spin.
Now, the real unbalance values of the wheel thus mounted on the wheel balancer are dis-
played. Take the wheel to the position shown on the monitor. The foreseen unbalances are
displayed by performing the matching and the proportional improvement which can be
obtained if the user decides to continue the optimisation procedure.
In case optimising is insufficient, or significant improvements cannot be obtained, select
the Exit key
exit the programme permanently); perform a spin to balance the wheel; otherwise, the
system goes to the third and final programme phase.
OPT PHASE 3
Following the indications on the monitor:
12. turn the wheel up to the position shown on the position indicator;
13. make a second mark on the tyre external side at 12 o'clock. If the indication to invert
the tyre mounting direction on the rim is displayed, make the second mark on the
internal side;
14. confirm you marked the tyre again by selecting Enter
15. remove the wheel from the wheel balancer;
16. turn the tyre on the rim (and invert mounting direction, if required) until the mark
made before matches the valve;
17. refit the wheel on the wheel balancer;
96
to confirm the execution;
twice (first to exit the procedure and restart the menu, and then to
;
;
;
User manual S 65
Publicidad
Capítulos
