Wheel Spin (Without Guard); Wheel Spin (With Guard); Automatic Position Search; Balancing Programmes - SICE S 65 Manual De Instrucciones

WHEEL SPIN (WITHOUT GUARD)

The wheel spin is performed by pressing the key
WARNING
No persons are permitted within the area demarcated by the dotted line while the
machine is in use Fig.6a.

WHEEL SPIN (WITH GUARD)

Wheel spins take place automatically by lowering the guard or pressing the start button
with the guard lowered.
A special safety device stops rotation if the guard is raised during the spin; in this case,
the A Cr message is displayed.
WARNING
Do not operate the machine without the guard and/or if the safety device has been
tampered with.
WARNING
Never raise the guard before the wheel has come to a stop.
WARNING
If the wheel keeps spinning permanently due to a fault on the machine, switch off the
machine using the main switch or disconnect the plug from the power supply board
(emergency stop) and wait until the wheel stops before raising the guard.

AUTOMATIC POSITION SEARCH

During position search, the wheel can rotate with the guard raised. Each time the start
button is pressed, you pass from the centred position of one side to that of the other
side. This function is active only if the RPA programme is set to ON (see "Automatic po-
sition search configuration (RPA)", a function present in the configuration programmes).

BALANCING PROGRAMMES

Before starting a balancing operation, the following steps must be followed:
- mount the wheel on the hub using the most suitable centring system;
- make sure that the wheel is locked correctly to the shaft so that no displacement can
occur during the spin and braking phases;
- remove any counterweight, pebble, dirt or other foreign body;
- set the wheel's geometric data correctly.
82
.
User manual S 65