Garant SB1 Manual De Uso página 49

2 Time in hh:mm format
7.3. PRINTING AND SCANNING
1
2
3
4
1 Set the label size for label printing
2 Perform a Test print
8. Cleaning
Before performing cleaning, disconnect the setting bench from the power supply. Make sure that no fluids penetrate into
the setting bench. Do not use chemical, alcohol-based, abrasive or solvent-based cleaners. Use only a lightly moistened mi-
crofibre cloth for cleaning.
Interval
As necessary
As necessary
1× annually
9. Maintenance
Maintenance personnel who have been trained in the respective activity, who have special technical
knowledge about the respective devices for performance of maintenance work and who are aware
of the hazards associated with working on devices of this type.
DANGER
Electrically live components
Risk of fatal electric shock.
» Before starting any maintenance work switch the unit off and disconnect it from the power supply, release it and pro-
tect it from being switched on again.
» Check that the system is electrically dead, earth it and short circuit it.
» Insulate any adjacent electrically live components.
» Maintenance and repair may be performed only by electrical specialists.
» If any live components suffer damage, have them repaired immediately.
Interval
1× annually
1× annually
Print & Scan
Label size:
Test print
Component
Screen, housing
Cover strip
Functional parts within the unit
Maintenance work
Check mechanical components.
Check and lubricate guide units (spindle
and slides).
4 Back to Settings
28×89
Reset scanner
3 Reset scanner
4 Back to Settings
Performed by
Trained person
Trained person
Hoffmann Group Customer Service
Performed by
Hoffmann Group Customer Service
Hoffmann Group Customer Service
25×54
www.hoffmann-group.com
de
en
cs
da
es
fi
fr
hr
hu
it
lt
nl
pl
ro
ru
sl
sv
49