MHZ art 01 Instrucciones De Montaje página 69

art_01 cassette awning installation instructions
Installation
Technical data
General installation information
! Fasteners may protrude max. 30 mm (from the bracket outer edge) into the ceiling or wall brackets so that the awning can be insert-
ed unimpeded during installation.
Installation with Fischer Thermax M16 60/170
! In the event the brackets are directly installed on Fischer Thermax M16 60/170, the enclosed washers must be used (4 pieces
Ø 13 mm DIN 9021).
Wall bracket on Fischer Thermax M16 with washers* (Ø 13 mm DIN 9021) (2 pieces per bracket)
1. Wall and ceiling installation
1.1 Determining unit width:
Measure cassette width (from outer edge of cast part to outer edge of
cast part) and add 146 mm (see Fig. 01, 02).
Unit width as measured below + 42 mm = centre of hole
to centre of side cover hole
Outer edge of cast part
Subject to technical changes, edition 09/2023
Ceiling bracket Wall bracket
*
*
Unit width = cassette width + 146 mm
73 mm
Fig. 01: Unit width
Fig. 02: Measuring cassette width
Cassette width 73 mm
13