MHZ art 01 Instrucciones De Montaje página 81

art_01 cassette awning installation instructions
Adjustment instructions for all Somfy OREA RTS radio drives
NB: The awning's end positions are set at the factory. No alteration is necessary unless you want to
reset the bottom end position.
Electrical connection
green/yellow
( PE )
2
1 3
blue empty
black
( N )
( L1 )
Special features of radio control systems
Features of the radio transmitters
Installation
Product no. 99 - 4196
Changing the lower end position
(Only necessary if the factory setting is to be altered)
The top and bottom end positions are set at the factory and do not
normally need any further programming.
If necessary, the bottom end position can be changed (the top end
position always stays the same).
1. Via the 'DOWN' button, extend the awning
completely (drive switches off automatically).
2. Press the 'UP' and 'DOWN' buttons simul-
Up / On
taneously for c. 5 seconds until the unit
briefly moves back and forth.
Stop
Down / Off
3. Via the 'UP' or 'DOWN' buttons set the
awning's new, desired end position.
4. Press the middle 'Stop' button until the unit
again briefly moves back and forth.
5. The bottom end position has now been
reprogrammed.
6. Trial run.
Subject to technical changes, edition 09/2023
The OREA RTS must be connected according
to the terminal assignments.
When making connections ensure that there is
no supply of power.
(Remove the fuse!)
Note: An electrician must perform the on-site
connection of drive system and controller.
Radio control systems' range is limited by the statutory regulations for wireless equipment and the
structural circumstances.
The control system should not be installed in the immediate vicinity of any metallic surfaces. Strong local
transmitter units (e.g. wireless headphones) that have a transmission frequency identical to the control
system can have an influence on its function. The transmission range is up to 300 metres in the open and
c. 20 metres inside buildings. The operating instructions of the Somfy radio transmitters being used must
be followed.
All suitable Somfy radio transmitters can be paired with and operate the OREA RTS
drive, e.g.: Telis 1 RTS, Telis 4 RTS, Telis Soliris RTS, Centralis RTS.
A maximum of 12 transmitters (including a maximum of 3 Sensor RTS transmitters) can be paired
with each OREA RTS drive.
In order to be able to operate the awning during installation, the drive must be connected to the Somfy
Up
test cable. For power to be supplied to the drive, the test cable's 'Up' button has to be pressed.
The drive can then be operated via the hand-held radio remote control unit supplied with it.
The remote control unit has been paired with the drive. The top and bottom default end positions have
also been set at the factory and do not need any further programming. In the top end position the drive
automatically switches off when it reaches a set level of rated torque.
The system is to be protected with an upstream FI circuit breaker in
accordance with VDE regulations.
Only cables and connectors with a protection class of a minimum of
IP 54 may be used to supply power.
Pair further transmitters
(Or delete paired transmitters)
A maximum of 12 transmitters (including a maximum of 3 Sensor RTS
transmitters) can be paired with the OREA RTS radio-controlled drive.
In order to pair further transmitters (or to delete them), you always need a
transmitter that has already been paired.
If no such transmitter is available to you, contact your specialist retailer to
get further information.
1. On the back of the transmitter already paired
with the radio-controlled drive press the
PROGramming button for c. 2 seconds.
The unit briefly moves and is thus 'Ready for
Pairing'
PROGramming
2. Briefly press the PROGramming button of the
button
transmitter to be newly paired (or deleted).
The unit again moves briefly back and forth.
3. The new transmitter has now been paired
(or deleted).
4. Trial run.
In order to prevent water running
along it into the motor, the connection
cable should always be laid with a
downward loop.
25