MHZ art 01 Instrucciones De Montaje página 77

art_01 cassette awning installation instructions
Installation
5. Gear adjustment
Step 1
SW 4
Step 1
Step 2
4
Subject to technical changes, edition 09/2023
Step 2
Step 2
4
6
Step 2
5
Step 1
The final setting of the gearbox is set at the factory.
If you still want to change the final setting, proceed as
follows:
Extend the awning until the freewheel clutch responds
(clear "click" sound). Then retract the awning approx.
1 to 2 cm.
Turn the retaining ring (1) of the eyelet (2) until the
dowel pin (3) for removing the eyelet is visible.
Remove the dowel pin.
Remove the extension (4) for adjusting the gearbox.
Step 1
Remove the pin lock (5) and pull the extension (4) out
of the bevel gearbox mount.
5
Gearbox adjustment:
Loosen the internal locking screw (6) with an Allen key
SW 4 by three turns. Refit the extension (4) and eyelet
(2).
When adjusting the end stop outwards (projection
increases):
Use the hand crank to briefly turn the awning inwards
(approx. 1 cm) to relieve the stop.
Then turn outwards to the desired end position.
!
This short travel movement prevents damage to
the adjusting toothing.
When adjusting the end stop inwards (projection
becomes smaller):
Use the crank handle to turn the awning inwards to the
desired end position.
Remove the eyelet and extension and retighten the
locking screw (6).
Then refit the extension (4) and eyelet (2).
Check the setting by retracting approx. 50 cm and then
extending until the freewheel clutch responds (clear
"clicking" sound).
Note:
Turn in the OPEN direction (towards the wall)
= projection becomes smaller
Turn DOWN direction (direction of drop-out)
= projection increases
21