MHZ art 01 Instrucciones De Montaje página 75

art_01 cassette awning installation instructions
Installation
2. Recess installation
2.4 Mounting brackets on recess brackets:
Mount the brackets on both sides; to do so, firmly tighten the supplied
hexagon screws (4 pieces M 10 x 25 DIN 933 A2). Observe the selected
installation variant and mounting method (see Fig. 18).
2.5 Next steps:
See pages 15 and 16 of the installation instructions
for the next steps in the installation process.
See pages 15, 16: 1.8 Mounting awning to 1.12 Incline adjustment
3. Roof rafter installation
Note: Recommended for projections up to max. 300 cm. Please
make sure to check the structural analysis of the sub-construction
beforehand. Produce sketch with position of the awning, the rafter
bracket (incl. installation position) and the rafter. In the case of
art_01, the brackets can only be installed on the very outside in
the area of the functional bearings. The centre-to-centre distance
cannot be changed. The unit width must be adapted to the rafter or
the centre-to-centre distance.
Wind resistance class 0 applies to installations on wood.
Ordering dimensions = unit width
Unit width = centre-to-centre distance + 104 mm
Centre-to-centre distance = left centre fixation point to right centre
fixation point
Adjustment range = +/- 17 mm per rafter bracket
4 x Ø 12
LL 14 x 47
Unit width = centre-to-centre distance + 104 mm
Centre-to-centre distance = centre fix. point (left) to centre fix. point (right)
Subject to technical changes, edition 09/2023
Installation variant 1
(standard)
RB 1 (left)
Installation variant 2
RB 2 (right)
Fig. 18: Observing mounting variant
82
48
+/- 19
Fix.
point
Ø 12
47
Bracket installed on left
Rafter
10
4
38
Centre-to-centre distance
Unit width
Bracket installed on left
Rafter
10
18
48
Centre-to-centre distance
Unit width
168
100
10
60
4 x Ø 12
Bracket installed on right
Rafter
10
4
48
Centre-to-centre distance
Unit width
Bracket installed on right
Rafter
10
18
38
Centre-to-centre distance
Unit width
19