MHZ art 01 Instrucciones De Montaje página 78

art_01 cassette awning installation instructions
Installation
6. Removal of the awning
6.1 Removing bracket covers:
Extend awning approx. 5 cm and remove console covers (2 pieces M
6 x 20 DIN 7991 A2) (see Fig. 16).
6.2 Removing securing screws:
Fully retract awning and remove all securing screws (2 pieces per
bracket, M 12 x 45 DIN 912 A2) (see Fig. 17).
! Disconnect the unit from the power supply in advance.
! If the securing screws are not present, it is dangerous to stand un-
derneath the awning and this area must only be entered by installers.
! Without the securing screws, the unit is not ready for use and
must not be operated!
6.3 Lifting out the awning on both sides:
! Two installers must unhook the awning or unlock the spring
mechanism at the same time on the left and right!
Slightly lift the awning on both sides and unlock the spring mecha-
nism using a slotted screwdriver (5.5 - 9 mm) (see Fig. 18/19). The
awning can then be removed downwards from the brackets.
1. Position slotted screwdriver
to unlock.
Fig. 19: Unlock the spring mechanism
22
2. Lever out spring mechanism; to
do so, lift or twist screwdriver.
Fig. 16: Remove bracket covers
*
Fig. 17: Remove securing screws*
Fig. 18: Position slotted screwdriver here
3. Spring mechanism is fully
unlocked.
*
4. Awning can be removed down-
wards from the brackets.
Subject to technical changes, edition 09/2023