MHZ art 01 Instrucciones De Montaje página 79

art_01 cassette awning installation instructions
Adjustment instructions for Elero SunTop drives
A. Note for the electrical installer
This awning must not be connected with the power live. Take fuse out beforehand!
There is a risk of the electronic end position setting being deleted. Resetting this is possible
only with the special Elero setting cable (prod. no. 99-1085).
The system is to be protected with an upstream FI circuit breaker in accordance with
VDE regulations. Only cables and connectors with a protection class of a minimum of
IP 54 may be used to supply power.
B. Important Notice
This unit is fitted with an electronic SunTop motor. The special Elero setting cable has to
be used to set the end positions. A conventional test cable can be used to operate the
unit, but not to set it!
The electronics within the drive unit function only when built into the fabric tube!
Work on the mains power may be carried out only by authorised specialists!
After setting the drive's end positions, secure these installation instructions to the cable
for the electrician!
When using your own control systems not included with the product (e.g. wind/sun sensors
or similar), you must ensure that a switch-over pause from retract to extend command of at
least 0.5 seconds is set in the controller.
Where operation is via switches, only push-button switches with a 'dead-man' circuit are
permissible and they must mutually disable each other.
In accordance with VDE regulations, the motor may not be supplied with continuous current.
Otherwise the SunTop drive cannot be guaranteed to function reliably!
Note: It is possible to connect multiple SunTop drives in parallel (max. 430 W per drive).
If doing so, pay attention to the switching point's maximum switching capacity.
D. End position setting
The end position setting of the SunTop drive is set at the factory and does not normally need any correction. If you do,
nevertheless, want to set the drive's end positions differently, please note the following points:
1.)
Connect the Elero setting cable to the drive's Hirschmann coup-
ling and run the unit out 30 cm. At the same time, press both
buttons on the setting cable. After c. 5 seconds, the drive goes
briefly up and down. The end positions have now been deleted
and can be reset
4.)
Press the DOWN button again.
Run out the awning to just
before the desired bottom end
position. The drive starts with
a short STOP.
Subject to technical changes, edition 09/2023
5.)
Move to the desired bottom
end position.
Corrections can be made via
the buttons.
Capacitor
Activation
button
2.)
Press the UP button again. Move
up to the top end stop. When the
stop is reached, the drive
automatically switches off.
6.)
Press the UP button until the
drive automatically stops.
The bottom end position has now
been set and the programming
finished.
C. Connection example
Junction box
2 3 1 4
1 0 2
Switch box
Mains 230 V/50
L1
N
PE
3.)
Press the DOWN button until the
drive automatically stops.
The top end position has now
been set.
The end positions are now set as
wished and the drive moves into
the respective end position.
Connect the Hirschmann
coupling to the control line again.
With this new drive there is no
need to simultaneously press the
UP and DOWN buttons after
resetting the end positions.
Pressing both buttons
simultaneously would put the
drive back into programming
mode (see point 1).
Winding
thermostatt
Electronics
23