Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT INSTALLATION
Before Installation
IMPORTANT NOTE: Please read through this entire list of instructions and take inventory of
included parts before beginning installation. If you have any questions at all, please call Customer
Service at 1-888-542-3355 before you begin your installation.
A GFCI electrical outlet near the toilet is needed to provide power. Ensure that the skirt of the
toilet does not interfere with the water supply point. Due to the nature of this product, a plumber
is recommended for installation.
1. Before unpacking this product, ensure
rough-in dimensions are as follows:
• The centerline of the floor drain is to
be 12" from the finished back wall.
Do not include the thickness of any
baseboard molding when taking this
measurement.
• Locate the included installation
template titled "Confirm Dimensions
Before Unpacking."
• Place the provided installation
template on the ground and trace
the outline with a marking pen to confirm rough-in dimension; remove
installation template before installing the unit.
• The centerline of the angle stop (water supply valve) is to be 8" above the
finished floor and 9"–11" to the left of the centerline of the floor drain. The angle
stop will need to have a ½" or 3/8" MIP thread to connect to the included T-Valve
2. Confirm water pressure:
The minimum operating water pressure is 35 psi / 0.24 MPa. If the operating
water pressure is below 35 psi / 0.24 MPa, the unit may experience issues
with the flushing mechanism. Use a water pressure gauge (not supplied) to
ensure there is adequate water pressure before installation.
3. Ensure there is enough space to properly install the unit.
Confirm Dimensions of Product with Installation Space
Rough-in
Drain hole
distance ≥12in
distance
12" / 30.48 cm
18.7" / 47.5 cm
18.7
15.75" /
15.75
40 cm
Side Profile
Water Supply Valve
Floor Drain
15.16" /
38.5 cm
15.16
Front View
GFCI Outlet
26.97" / 68.5 cm
Top View
12
Publicidad
