Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT OPERATION
Using the Sutro
NOTE: The Sutro has a built in seat sensor.
Wash and dry functions will not work unless
the sensor in the seat detects someone
sitting down. To override the seat sensor,
please see the instructions on page 22.
Prepare for Wash
Sit on the seat to ensure skin-to-seat
contact on the seat sensor. Once contact is
made, the seat will automatically:
1. Give an audible "beep" letting you know
the seat sensor has been engaged.
2. Initiate a bowl-cleaning pre-rinse to
prepare for use.
3. If the bidet was set to Eco Mode,
the seat temperature will rise to the
previously set temperature setting.
Warm Water Wash
When ready to wash, press the rear or front
wash button on the remote control one time
to initiate a wash. The nozzle will
self-clean, extend into the toilet bowl, spray
for 4 minutes, turn off automatically, retract,
and self-clean once again.
1. While washing, users can adjust the
water temperature, pressure, and nozzle
position settings.
2. If you would like to stop the wash before
the 4-minute cycle ends, press the stop
button to discontinue water flow.
19
Advanced Air Dry
Press the advanced air dry button to start a
warm air drying cycle. The dryer will run for
4 minutes and turn off automatically.
1. While the air dryer is operating, users
can press the advanced air dry button
repeatedly to adjust the fan speed level
between low, medium, or high.
2. The temperature can also be adjusted
between 4 different levels using the dryer
temperature button. The temperature
setting will be illuminated on the LED
indicator lights on the remote.
3. To stop the dryer during the cycle, press
the stop button.
Deodorizer
This unit is equipped with an automatic
deodorizer that will turn on when the seat
sensor is activated. The deodorizer will
continue to run for 3 minutes after leaving
the seat.
NOTE: The deodorizer will not turn on if the
seat sensor is overridden. To turn off the
automatic deodorizer, press and hold the
dryer temperature button for 3 seconds. The
unit will beep to confirm saved settings.
Publicidad
