TECHNICAL INFORMATION
Regulatory and Safety Notices
USA: Federal Communications Commission
(FCC) Statement
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful
interference;
and
2. This device must accept any interference,
including interference that may cause
undesired operation of the device.
FCC Warning
Changes or modifications not expressly approved
by the party responsible for compliance
could void the user's authority to operate the
equipment.This device should be installed and
operated with minimum 20 cm between the
radiator and your body.Note: This equipment has
been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the
equipment and receiver.
•
Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/TV
technician for help.
•
This device meets the FCC and IC
requirements for RF exposure in public or
uncontrolled environments.
33
Canada: Industry Canada (IC) Statement
This device meets the IC requirements for RF
exposure in public or uncontrolled environments.
IC Notice to Users English/French in accordance
with current issue of RSS GEN:
This device complies with Industry Canada license
exempt RSS standard(s).
Operation is subject to the following two
conditions:
1. This device may not cause interference, and
2. This device must accept any
interference,including interference that may
cause undesired operation of the device.