Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT OPERATION
Auto Mode, Pre-Rinse, and Auto Flush
Auto Mode
Press the rear or front wash button on the
auxiliary control panel to engage auto
mode. During auto mode, the following
wash parameters will be set:
•
Seat temperature set to level 3
•
Move (nozzle oscillation) turned on
•
Water pressure set to level 3
•
Water Temperature set to level 3
•
Dryer temperature level set to level 3
Pressing the rear or front wash button
on the auxiliary control panel during the
wash cycle will stop the wash and start the
drying function.
After the wash cycle is completed, auto
mode will initiate a flush followed by
a 4-minute warm air dry cycle on the
auxiliary control panel. Pressing the rear or
front wash button during the dry cycle will
adjust the fan speed level.
NOTE: You can preselect desired wash and
dry settings on the remote before starting
Auto Mode, otherwise all settings will
default to level 3.
Pre-Rinse
When the seat sensor is activated, the unit
will provide a pre-rinse to the toilet bowl to
help combat debris buildup and staining.
Press and hold the up arrow button for 3
seconds to deactivate this feature.
Auto Flush
The auto flush mode is activated at the
factory by default. The toilet will flush
automatically when it detects a user has
vacated the seat after 6 seconds or more.
To turn off auto flush mode, press and
hold the down arrow button for 3 seconds.
The unit will beep once to confirm saved
settings. To reactivate auto flush, repeat
the step above. The unit will beep twice to
confirm saved settings.
Auto Flush Before Dry
By default, the unit will flush when the
advanced air dryer is activated. Press and
hold the advanced air dryer button for 3
seconds to deactivate the flush before dry
feature.
NOTE: The flush before dry feature will not
work if a flush command has previously
been made.
20
Publicidad
