Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
Cleaning the Mesh Filters
Cleaning the Mesh Filters
If your Sutro seems to be experiencing a
loss of water pressure, your mesh filters
may be dirty or clogged and should
be cleaned. Follow the steps below to
clean the filters. If the pressure issue
is not resolved after cleaning, see the
Troubleshooting section at the end of this
manual for other possible solutions.
Cleaning the T-Valve Mesh Filter
1. Unplug the power cord from the wall
outlet.
2. Shut off the water supply valve at the
wall.
3. Disconnect the top bidet hose from
the T-Valve only. Use pliers to remove
the mesh filter. NOTE: You will need
a bucket or towel to catch residual
water within the hoses and valve.
4. Clean the mesh filter with water and
soft brush, then reinsert back into the
T-Valve , with the "x" side facing up.
Ensure the filter is pushed in all the
way and reconnect bidet hose until
secure.
5. Slowly turn on the water supply
valve and check for any leaks. Wait
5 minutes and check for leaks again
before plugging the unit back into the
GFCI outlet.
Step 3
24
Publicidad
