Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT OPERATION
Remote Control
1
2
3
1. Insert the AAA batteries.
a. Open battery compartment cover on backside of remote control by pulling down on
the tab to release the cover.
b. Insert two AAA batteries (included), ensure batteries are installed correctly.
c. Replace battery compartment cover.
2. Mount the remote (optional)
a. Identify a location in the bathroom for the remote control that is visible and
reachable from the toilet.
b. Use the included mounting screws or peel off the double-stick tape on the back of
the wall mount and press firmly to the wall to ensure that it does not fall and damage
the remote control.
NOTE: The remote control is paired to the product by default at the factory. If the remote control
is not working properly, double check the batteries or re-pair the remote using the remote pairing
instructions below.
Remote Pairing Instructions
1. Unplug the unit.
2. Hold the stop button on the remote until the LED indicator lights on the remote start
to flash.
3. While the lights are still flashing, plug the unit back into the GFCI outlet.
4. The lights will stop flashing, and the remote is now paired with the unit.
5
14
4
8
10
13
12
7
6
9
11
15
16
Publicidad
