Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT INSTALLATION
Installing the Emergency Flush Battery
In the event of loss of power to the Sutro,
the flush button located on the auxiliary
control panel can be used to manually flush
the toilet. Follow the instructions below to
install the 9V battery underneath the bidet
seat before proceeding with installing the
Sutro.
1. Remove the top bidet unit by grabbing
the back-top corners of the bidet and
gently, but firmly pull up towards you to
release the bidet from the ceramic base.
Be careful not to damage any hoses,
power cords, or connections as you
remove the bidet.
2. Use a Phillips-head screwdriver to
release the screws and remove the
cover.
3. Connect the included 9V battery to the
terminal wire. Ensure you have properly
connected the battery to the correct
polarities and replace the battery
compartment cover.
4. Feed the bidet hose, flush hose, and
power cord back through the ceramic
base cavity, ensuring none of the water
supply hoses become pinched or
kinked.
5. Reinstall the bidet seat onto the ceramic
base; evenly press down until you hear
the bidet snap into place.
13
Step 1
Step 2–3
Publicidad
