Virutex EB140 Manual De Instrucciones página 109

Fig. 46
G
H
B
Changing the lower bit:
• Remove the screws G (Fig. 46), using the service key.
• Remove the cover H (Fig. 46).
• Remove the copier group through the window left free by the
cover H, (Fig.46).
You may support the copier group under the table so that it does
not fall when removed from the machine, accessing it through
door B (Fig. 41).
• Change the bit in the same way described in the previous sec-
tion.
• Keep in mind that the screw fastening the bottom bit has a
left-handed thread.
• Once the bit has been changed, replace the cover H, (Fig. 46).
CAUTION
If the new bit is not the same model as the one that was
mounted, you must readjust the trimming unit, as explai-
ned in section 5.6 of this manual.
(Figure 41)
EB140 / Operating instructions - 109