Edge Advance Speed Control; Gluing Roller Speed Control - Virutex EB140 Manual De Instrucciones

I
J
P2
P2
P1
B
5.2.4 Edge feeding speed control
P2
The edge feeding speed leaves the factory pre-set so that the
edge reaches point B (Fig. 24.3) at its outlet and waits for the
next board to arrive.
If it becomes necessary to reset the speed, loosen nut F (Fig.
H
24.1) and turn knob G (Fig. 24.1) clockwise if you wish to
reduce the speed, or counterclockwise if you wish to increase
it.

5.2.5 Gluing roller speed control

Gluing roller H (Fig. 24.3) is aided by a temporary rotation
movement. This assistance is necessary for the edge to be
(Figure 24.3)
perfectly glued on the front part of the board, particularly
on the first 2-3 cm.
If you notice that the edge comes unglued on the front end,
you must increase the speed of gluing roller H (Fig. 24.3) by
opening valve J (Fig. 24.3) on cylinder P2. To do this, you must
first loosen lock nut I (Fig. 24.3) on the valve.
Likewise, if you notice that there is too much glue being de-
posited on the front end, you must reduce the speed of gluing
roller H (Fig. 24.3) by closing valve J (Fig. 24.3).
EB140 / Operating instructions - 89