TOHATSU MD 30B2 Manual Del Propietário página 86

84
INSPECTION AND MAINTENANCE
engine stop switch lock attached to the
switch, and star ter key attached, or
engine could accidentally start leading to
serious personal injury. Disconnect bat-
tery cable if possible.
The propeller edge is thin and sharp.
Wear the groves during replacement to
protect your hands.
ENOW00086-0
Do not install propeller without thrust
holder, or propeller boss could be dam-
aged.
Do not reuse split pin.
After installing split pin, spread the pin
apart to prevent it from falling out which
could lead to the propeller coming off
during operation.
A worn-out or bent propeller will lower
the motor's performance, and cause
engine trouble.
1. Put a piece of wood block between
propeller blade and anti-ventilation
plate to hold propeller.
10
2. Remove the split pin, propeller nut
and washer.
3. Remove the propeller and thrust
holder.
CAUTION
ENOF00084-B
4. Apply water proof grease to the pro-
peller shaft before installing a new
propeller.
5. Install the thrust holder, propeller,
stopper, washer and propeller nut
onto the shaft.
30, 40, 50
2
1. Propeller
2. Thrust holder
3. Stopper
4. Washer
5. Propeller nut
6. Split pin
75, 90, 115
2
1. Propeller
2. Thrust holder
3. Bush
4. Stopper
5. Washer
6. Propeller nut
7. Split pin
6
3
5
4
1
ENOF01315-0
7
4
6
5
3
1
ENOF01336-0