Remote Control Device Installation; Remote Control Box Location - TOHATSU MD 30B2 Manual Del Propietário

30
INSTALLATION
75, 90, 115
1
5
1. Bolt (12 mm × length 105 mm)
2. Washer (large diameter)
3. Nut
4. Washer (small diameter)
ø13
(0.5")
1. Top of transom
ENOW00008-A
Mounting bolts should be installed with
the bolt head at inside sur face of the
transom. Mounting bolts installed with
the threaded end at the inside surface of
the transom can cause personal injury.
Tighten the bolts sufficiency, otherwise
falling down of outboard could be hap-
pened.
2
3
4
ENOF00614-0
327
(12.9")
1
51 (2")
17.5 (0.7")
17.5 (0.7")
17.5 (0.7")
251
(9.9")
ENOF00615-0
CAUTION
ENON00003-0
Notes
1. Apply sealing agent, such as silicone
sealed between the bolts and the
transom board holes before tighten-
ing the bolts.
2. Be sure to tighten the mounting bolt
nuts to the specified torque.
(30 N·m (3.0 kgf·m) 13 ft·lb)
ENOM00840-0
2. Remote control device
installation
ENOW00850-0

Remote control box location

1. Shift cable
2. Throttle cable
3. Cable harness B
Install the remote control box in a posi-
tion where it is easy to reach and oper-
ate the controls.
Make sure there are no obstacles that
can interfere with the operation of the
remote control cable.
3
1, 2
ENOF00841-1