Multiplex KIT FUNRAY Instrucciones De Montaje página 26

Building instructions
But take care - there are dangers for your model lurking at the slope.
Firstly, in most cases landing is much more difficult than at a flat field
site. It is usually necessary to land in the lee of the hill where the air is
turbulent; this calls for concentration and a high-speed approach with
last-minute airbrake extension. A landing on the slope face, i.e. right in
the slope lift, is even more difficult. Here the trick is to approach slightly
downwind, up the slope, and flare at exactly the right moment, just before
touch-down.

60. Aero-towing
An ideal combination for learning to aero-tow, and for actual aero-towing,
is a FunCub and a Heron.
For the tow you require a 20 m length of braided cable of 1 to 1.5 mm Ø.
Tie a loop of nylon line (0.5 mm Ø) to the glider end of the cable; this acts
as a "weak link", in case the tow should go badly wrong.
A loop in the other end of the towline should be connected to the aero-
tow coupling of the FunCub. Assemble the models, connect them as
described, and set them up directly into wind, the glider behind the tug.
Check that the towline is resting on top of the FunCub's tailplane. The
tug now rolls forward until the towline is taut, and only then should the
tug's pilot apply full-throttle. Both aeroplanes accelerate: the tug stays
on the ground initially, while the glider lifts off, but the glider pilot keeps
his model flying low above the ground, directly in the wake of the tug;
the tug can now lift off safely. The two models should be kept climbing
steadily, even through turns. Avoid flying directly over your heads during
the first few attempts at aero-towing, as it is difficult to detect the models'
attitudes from this angle. To drop the tow, operate the transmitter control
which opens the tow release mechanism.
61. Electric flying
With the electric version you have the optimum level of autonomy and
independence. You can fly from a flat field and carry out about seven
climbs to a sensible gliding height (around 150 m) from a single battery
charge. At the slope you can also keep the electric power system as a
"lifebelt", i.e. you only use the motor to "keep afloat", and avoid landing
out, i.e. landing at the bottom of the slope when the lift fails.
62. Flight performance
What is meant by a glider's performance?
The two most important parameters are sinking speed and glide angle.
Sinking speed is a measure of the vertical height lost per second relative
to the surrounding air. The sinking speed is primarily determined by the
wing loading (weight relative to wing area). Here the Heron offers a really
excellent performance - much better than conventional models - as its
wing loading is so low. This means that only slight thermal assistance
is necessary (warm air rising) to cause the model to gain height. Wing
loading is also the main factor in determining the model's airspeed -
the lower the loading, the slower the model. Low airspeed means that
the model can be turned extremely tightly, and this is also advantageous
when thermal flying, as areas of lift are usually very small when close to
the ground.
The other important parameter in glider performance is the glide angle.
This is stated as a ratio, i.e. from a particular altitude the model flies such
and such a distance. The glide angle increases as wing loading rises,
26
and at the same time - of course - the model's airspeed increases. This
becomes necessary if you wish to fly in relatively strong winds, and when
you need "energy retention" for flying aerobatics.
For thermal flying you need a good glide angle too, as this is the key to
flying across areas of "sink" (the opposite of a thermal) quickly, so that
you can seek out another thermal.
63. Safety
Safety is the First Commandment when flying any model aircraft. Third
party insurance is mandatory. If you join a model club, suitable cover
will usually be available through the organisation. It is your personal
responsibility to ensure that your insurance is adequate (i.e. that its cover
includes powered model aircraft). Make it your job to keep your models
and your radio control system in perfect order at all times. Check and
observe the correct charging procedure for the batteries you are using.
Make use of all sensible safety systems and precautions which are
advised for your system. An excellent source of practical accessories is
the MULTIPLEX main catalogue or our website www.multiplex.de
MULTIPLEX products are designed and manufactured exclusively by
active modellers for practising modellers. Always fly with a responsible
attitude. You may think that flying low over other people's heads is proof
of your piloting skill; others know better. The real expert does not need
to prove himself in such childish ways. Let other pilots know that this is
what you think too, as it is in all our interests. Always fly in such a way that
you do not endanger yourself or others. Bear in mind that even the best
RC system in the world is subject to outside interference. No matter how
many years of accident-free flying you have under your belt, you have no
idea what will happen in the next minute.
Before every flight, check that the battery, the wings and the tailplane
are attached and firmly seated. Check in turn that each control surface is
operating correctly!
We - the MULTIPLEX team - hope you have many hours of pleasure
building and flying your new model.
MULTIPLEX Modellsport GmbH &Co. KG