Safety Advice Concerning The Visor / Sun Visor; Safety Advice Concerning Modifications / Accessories; Outer Shell; Visor And Sun Visor - SCHUBERTH J1 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

G. FOR YOUR S FETY

2. SAFETY ADVICE CONCERNING THE VISOR / SUN VISOR

The protective film fastened to the visor to protect it from
scratches in transit should be removed before use.
A scratched and/or dirty visor or sun visor considerably impairs
visibility – especially at night or when riding into the sun – and
increases the risk of an accident. For your own safety, replace or
clean the visor immediately.
Never use a tinted visor in conditions of poor visibility or at night
or in a tunnel!
Benzene, solvent and fuel vapour can cause cracks on the visor.
Keep the visor away from such vapours and do not allow these
kinds of substances to come into direct contact with the visor!
For that reason, never place the helmet on the tank of your
motorcycle.
Make sure the visor is always in perfect condition. Don't ride
when visibility is poor!
3. SAFETY ADVICE CONCERNING MODIFICATIONS /
ACCESSORIES
Original parts (especially on the outer shell, inner shell and
retention system) should not be modified or removed. The
fitting of non-genuine, non-recommended parts can partially or
completely counteract the protective function of the helmet and
invalidate the ECE approval together with all guarantee and
insurance rights.
Use only original parts, replacement parts and accessories that
SCHUBERTH has expressly approved for your helmet!
88
H. M INTEN NCE
ND C RE

1. OUTER SHELL

To clean the helmet shell, you can use water, soapy water or one of
the commonly available motorcycle shampoos, cleaners, polishes and
plastic cleaners, or cleaning fluid. The use of water and soapy water is
usually sufficient. Make sure when using the other cleaning materials
that these do not come into contact with the visor, since these can
cause damage to the visor and coating.
Note:
Never use motor fuel, thinners or solvents to clean the helmet.
These substances can cause serious damage to the helmet with
no externally visible indication. The full safety function of the
helmet is then no longer guaranteed.

2. VISOR AND SUN VISOR

Outside surface of the visor
Only use a soft cloth and mild soapy water to remove dirt from the
outer surface of the visor. Use a lint-free cloth to dry the visor.
(we recommend a microfibre cloth)
I nsi de surf ace oft he vi sor
Only use a soft, if necessary slightly moistened cloth (we recommend
a microfibre cloth) to clean the inside surface of the visor. Do not use
any cleaning agents for this. To protect the anti-fog coating, avoid
vigorous rubbing.
Sun vi sor
The advice given for cleaning the inside surface of the outer visor
also applies to the sun visor.
89

Publicidad

Tabla de contenido
loading

Tabla de contenido