Access The Web Ui Using The Device Ip Address; Access The Web Ui Using The Digi Device Discovery Utility - Digi Connect WS Manual De Referencia De Hardware

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 105
configuration settings Home page. If you don't know your device's IP address, you can access the web UI of your
device in a similar way by using the Digi Device Discovery Utility.
The web UI, which is available via a local area network connection to the device, provides an easy way to configure
your device settings and perform administrative tasks.
The following sections demonstrate how to access the Connect WS web interface by using an IP address, as well as the
Digi Device Discovery Utility. Device information displayed within the web UI varies by model.

Access the web UI using the device IP address

Basic HTTP authentication is enabled in the device. You will need to know the administrative username and password
to access the device's configuration settings page.
1 Open your preferred web browser.
2 In the URL address bar, enter the IP address of your device.
3 Enter your username and password. If this is the first time you are accessing the device's web UI:
Username:
Password:
password is admin. If neither password works, the password may have been updated. Contact your system
administrator.
4 The device's configuration settings Home page is displayed.

Access the web UI using the Digi Device Discovery Utility

The Digi Device Discovery Utility locates Digi devices on a network. It allows you to open the web interface for
discovered devices, configure network settings, and reboot the device. It uses a Digi International-proprietary
protocol, Advanced Digi Discovery Protocol (ADDP), to discover devices on a network, and displays the discovered
devices in a list.
The Digi Device Discovery Utility is available for download on the Digi support site. To download the Digi Device
Discovery Utility, proceed with the following steps:
1 Open your web browser, and navigate to www.digi.com/support.
2 Under Select Your Product for Support, select Device Discovery from the product list.
3 Select Diagnostics, Utilities and MIBs in the navigation bar located on the left side of the page.
4 Under Operating System Specific Utilities, select your appropriate operating system from the drop-down menu.
5 Select Device Discovery Utility for Windows-Standalone Version. The standalone version runs the utility
immediately after the download is complete.
Connect WS Hardware Reference Manual
admin
The default password is printed on the device label. If a password is not on the label, the default
Connect WS configuration
29

Publicidad

Tabla de contenido
loading

Productos relacionados para Digi Connect WS

Tabla de contenido