Electromagnetic Guidance And Manufacturer's Declaration; Electromagnetic Effects; Electromagnetic Emissions - Digi Connect WS Manual De Referencia De Hardware

Additional considerations:
•
There are no operator controls on the device.
•
Other than these instructions for placement and initial setup and configuration, there are no additional
requirements for operator access or positioning of the device.
•
No additional setup is required from the operator.
•
Any additional required configuration or troubleshooting is done remotely following the specific procedures that
the Systems Integrator supplies for use of this product with their software.
•
If you need to troubleshoot the device while it is in use, you must refer to the instructions from the Systems
Integrator whose software is being used. Always contact the Systems Integrator when you are unsure how to
proceed when using the device.
•
For product RMA or questions concerning specific instructions in this manual, contact Digi Technical Support.
However, Digi cannot give guidance on the correct method of use or suitability of use of this product with any third
party equipment or software.

Electromagnetic Guidance and manufacturer's declaration

Electromagnetic effects

Connect WS is an electronic device that both emits and absorbs intentional and unintentional electromagnetic
radiation. It is designed and tested to comply with EN/IEC 60601-2. Improper installation not following this user guide
may cause this device to interfere with other electronic devices, including, but not limited to, Medical Electrical (ME)
equipment.
Consideration must also be taken regarding the potential presence of portable or mobile RF communications
equipment that may also impact nearby equipment.
The customer or user needs to make sure that recommendations of other equipment manufacturers are followed
especially concerning accessories, power supplies and cables for any device that is in proximity to the Connect WS or
that is connected to it, otherwise increased emission or reduced immunity may occur.

Electromagnetic emissions

Connect WS is designed and tested to comply and operate within the limits specified below.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic
emissions IEC
61000-3-2
Voltage
fluctuations/flicker
emissions IEC
61000-3-3
Connect WS Hardware Reference Manual
Compliance Electromagnetic environment guidance
Group 1 The Connect WS is a very low power device and generates very low levels of
Radiated Spurious Emissions. The potential for unwanted interference with
nearby electronic devices is very low.
Class A The Connect WS is suitable for use in all establishments other than domestic
and those directly connected to the public low-voltage power supply network
that supplies buildings used for domestic purposes.
Class A The Connect WS is a very low power device and generates very low levels of
Radiated Spurious Emissions. The potential for unwanted interference with
nearby electronic devices is very low.
Complies None.
Electromagnetic Guidance and manufacturer's declaration
39