Electromagnetic Immunity - Digi Connect WS Manual De Referencia De Hardware

Electromagnetic immunity

Connect WS is intended for use in electromagnetic environments within the limits specified below. The customer or
user of Connect WS should assure that it is used in such an environment.
Immunity test
Electrostatic
discharge (ESD) IEC
61000-4-2
Electrical fast
transient/burst IEC
61000-4-4
Surge IEC 61000-4-5
Connect WS Hardware Reference Manual
IEC 60601 Compliance
test level level
±6 kV ±6 kV contact
contact
±8 kV air ±8 kV air
±2 kV for ±2 kV for
power power supply
supply lines
lines
±1 kV for ±1 kV for
input/ input/output
output Lines
Lines
±1 kV ±1 kV line(s) to
line(s) to line(s)
line(s)
±2 kV ±2 kV line(s) to
line(s) to earth
earth
Electromagnetic Guidance and manufacturer's declaration
Electromagnetic environment guidance
Floors should be wood, concrete or ceramic tile. If floors are
covered with synthetic material, the relative humidity should
be at least 30%.
A typical commercial or hospital environment mains power
source is suitable.
A typical commercial or hospital environment mains power
source is suitable.
40