Commissioning The Vs With A Bus Coupler; Replacement - Aventics DeviceNet Instrucciones De Servicio

74 AVENTICS | DeviceNet | R402003659–BAL–001–AG

Replacement

7.4

Commissioning the VS with a bus coupler

Before commissioning the system, the following steps must have been
carried out and completed:
W
You have assembled the valve system and the bus coupler
(see "Assembling the CL03/CL03-XL with bus coupler" on page 61).
W
You have connected the bus coupler (see "Connecting the bus
coupler electrically" on page 63).
W
You have made the settings and configured the system
(see "Making settings" on page 67).
W
You have configured the bus master so that it controls the valves
correctly.
Commissioning may only be carried out by qualified electrical or
pneumatic personnel or an instructed person under the direction
and supervision of qualified personnel (see "Personnel
qualifications" on page 56).
Uncontrolled actuator movements when the pneumatics are
switched on
Danger of injury if the system is in an undefined state and the
manual overrides are set to position "1".
O
Put the system in a defined state before switching it on.
O
Set all manual overrides to position "0".
O
Make sure that no personnel are within the hazardous zone
when the compressed air supply is switched on.
O
Also observe the applicable instructions and safety information
in the VS operating instructions.
1. Switch on the operating voltage.
2. Check the LED displays on all modules.
3. Switch on the compressed air supply.
8 Replacement
A faulty bus coupler may have to be replaced with a new bus coupler.
You may also replace a multipole connector or another field bus module
of a CL03/CL03-XL VS with a bus coupler.
The warranty from AVENTICS only applies to the delivered
configuration and extensions that have been taken into account in
CAUTION