VDO KIMAX Instrucciones De Uso página 40

Technical specifications
When severing compressed air lines, en-
sure that the cuts are straight and
smooth.
• Cut a compressed air line leading directly to
the suspension bellows at the desired connec-
ting point.
For compressed air systems with Ø 8 mm po-
lyamide lines:
• Push the ends of the cut line into the respective
ports of the tee connector.
To disconnect a line from the connector,
push the ring in a little way and pull the
line out.
If you are installing a KIMAX axle load display
with two sensor connections:
• Connect the second tee piece into the se-
cond compressed air suspension circuit.
14
For compressed air systems with other cable
types:
• Use connectors appropriate to the vehicle and
complying with DIN 73377, such as hollow
bolts, ring or pipe connectors.
TU00-0880-1024450
KIMAX