Vehicle Hand-Over; Display Mode - VDO KIMAX Instrucciones De Uso

Calibration

Vehicle hand-over

Instruct the vehicle's keeper in the operation of
KIMAX.
Hand these installation and operating instruc-
tions to the vehicle's keeper.
Make sure that the vehicle's keeper knows that
the document of compliance issued by DEKRA
for the KIMAX axle load display device must be
kept with the vehicle papers.
The document of compliance is attached at the
end of this document.
26
Operation

Display mode 000:

As soon as the display unit is connected to vehic-
le voltage, it is active.
To display the current axle load, press the
key. The display extinguishes automatically after
about two minutes.
Display mode 111:
As soon as the display unit is connected to vehic-
le voltage, it permanently indicates the current
axle load.
TU00-0880-1024450
KIMAX