Compatible Accessories And Peripherals (Sonosite Edge Ii) - FujiFilm SonoSite Edge II Manual De Instrucciones

IEEE 802.11a with Orthogonal Frequency Division Multiplexing (OFDM) at 11 dBm ± 2 dBm @ 54 Mbps
IEEE 802.11b with Direct Sequence Spread Spectrum (DSSS) at 16 dBm ± 2.0 dBm @ 11 Mbps
IEEE 802.11g with Orthogonal Frequency Division Multiplexing (OFDM) at 13 dBm ±2.0 dBm @ 54 Mbps
IEEE 802.11n with Orthogonal Frequency Division Multiplexing (OFDM) at 12 dBm ± 2.0 dBm
(802.11gn) @ MCS7

Compatible accessories and peripherals (SonoSite Edge II)

FUJIFILM SonoSite has tested the SonoSite Edge II ultrasound system with the following accessories and
peripherals and has demonstrated compliance to the requirements of IEC60601-1-2:2007 and IEC60601-
1-2:2014.
You may use these FUJIFILM SonoSite accessories and third-party peripherals with the SonoSite Edge II.
ultrasound system.
WARNINGS
Table 1-1: Accessories and peripherals compatible with Edge II ultrasound system
Description
C8x transducer
C11x transducer
C35x transducer
rC60xi transducer standard/armored
HFL38xi transducer standard/armored
HFL50x transducer
For transducers, the maximum cable length is measured between the strain reliefs. The stated length do not include
the lengths of cable in the following locations: underneath the strain reliefs, inside the transducer enclosure, and
inside the transducer connector.
a
The L52x transducer is for veterinary use only.
12
Use of the accessories with medical systems other than the Edge ultrasound
system may result in increased emissions or decreased immunity of the medical
system.
Use of accessories other than those specified may result in increased emissions
or decreased immunity of the ultrasound system.
The ultrasound system should not be used in a domestic establishment or
connected to the public mains network.
Maximum Cable Length
6.0 ft / 1.8 m
6.0 ft/1.8 m
5.5 ft / 1.7 m
5.5 ft/1.7 m
5.5 ft/1.7 m
5.7 ft/1.7 m
Compatible accessories and peripherals (SonoSite Edge II)