Automatic Operation - Alpine ALS 4.0 Manual De Instrucciones

TEXT VIEW – Allows the current TRS file to
F.
viewed/edited as a text file.
G. E-MAIL FILE – Will setup the current TRS file
as an email attachment for Alpine Equipment
Support. This requires internet access at the
saw. Also, the saw must have an assigned email
address.
H. STRIP UN-CUT – Any Un-cut pieces can be
stripped from the selected TRS file and written
to another specified REDIR PATH location in the
General Options screen.
PRINT UNCUT – Print a cut sheet, with cutting
I.
information, for all pieces which have not been
cut in the selected TRS file.
MOVE OR DELETE FILE – Moves or deletes
J.
the current TRS file. If move is selected, it will
be copied in the folder designated in the
AEPSaw.ini file, "[datalog]" section, on the
"movecutfilepath=" line.
K. REMOVEABLE STORAGE -> HD – Copies the
contents of removeable media to location
pointed in the AEPSaw.ini file, "[general]
section, on the "copypath=" line.
MULTIPLY JOB QUANTITY – This option
L.
multiplies the quantities of all pieces within the
selected job.
M. CHANGE PIECE QUANTITY – This option
changes the quantity of a single piece that is
selected.
N. CAPTURE CURRENT PIECE – Selecting this
button will capture the current piece for use as
a Standard Piece or within another TRS file.
O. View Task1.prg – This is a troubleshooting tool
used by Alpine Equipment Support.
CAUTION
!
Do not press this button without assistance from
Alpine Equipment Support.
EXIT – Exits the user out of the UTILITY screen.
P.
6) CREATE PICK LIST – Creates a pick list for the
selected TRS File.
3.3

Automatic Operation

Click or touch AUTO to enter the Automatic Operation
mode. It will bring up the Job/Piece Select Screen
1
2
3
4
5 (top), 6 (bottom)
• Jobs available to cut are listed on the left side.
Clicking or touching a job description will highlight
it with the blue bar.
• Detailed information about the job is displayed on
the right side of the screen. Click or touch any piece
to highlight it in yellow and display all its cutting
and description details in the upper window.
• The scroll bar on the right side of the screen, or the
PREV and NEXT buttons below can be used to look
through the entire job. Pieces in red have been
completely cut. When a piece is in blue, it means
that some of its quantity has been cut, but not all.
• Highlight a blue piece to see the details; the upper
window will show the total quantity and the
number that have been cut.
Information about the job is located in the lower left
corner (Figure 12):
TOTAL SETUPS indicates the total number of
1.
unique pieces in the job.
TOTAL PIECES is TOTAL SETUPS times the quantity
2.
for each.
EST JOB TIME displays the amount of time required
3.
to complete the job
4. LONGEST PIECE indicates the length of the longest
piece in the TRS file.
5. CURRENT STOCK LENGTH shows the size of stock
currently chosen for running the job.
This is very important information because it informs
the computer what length stock is being used to cut the
job. Clicking or touching the white box will bring up a
screen that allows a choice of the proper stock length.
11
EN
ALS 4.0
P R O D U C T M A N UA L
7 8 9
Figure 12