Manual Mode Controls - Alpine ALS 4.0 Manual De Instrucciones

each axis. Once the data in entered press the Move
button to initiate the axis movement.
Figure 28
CAUTION
!
There is no "bounds-checking", so be careful not to move an axis
into a position that will cause a wreck or a crash.
HOME functions – These buttons will cause a
2.
single axis to Home. Machine calibration (located in
Section 4) may require homing a single axis.
3. CAL functions – Each of these buttons brings up
the message shown in Figure 29.
CAUTION
!
Be very careful when using these functions. Serious cutting and
operational problems or damage can occur if calibration is not
performed correctly.
Figure 29
CAUTION
!
Make absolutely certain that the axis is at the stated position
before clicking or touching OK.
3.5.2

Manual Mode Controls:

2
3
1. Z1 AXIS – The buttons on this panel are short
cuts for moving the Z1 axis. UP moves the blade
to its normal up position. DOWN moves the blade
to its maximum down position. FULL causes the
blade to make a full stroke down and back up like
it does when cutting lumber. All these moves are
performed at full system speed.
2. L1/L2 CLAMP UP/DPWN – The buttons on this
panel control clamp rollers that grip the top of the
board on each drive.
L1/L2 PUSHER IN/OUT – The buttons on this panel
3.
control the pusher fence that locates and maintains
the location of the board against the back fence
rollers.
OUTFEED – Toggle button which turns ON/OFF the
4.
powered rollers on the outfeed side of the saw.
SAW MOTOR and WASTE CONVEYOR – Toggle
5.
buttons turn the saw blade and the waste conveyor
ON/OFF.
6. HOME SYSTEM – Button that when clicked or
touched will seek the home position of all axes and
then return to the rest position.
ENABLE/DISABLE CUTTING – Toggle button which
7.
starts/stops the cutting process.
ENABLE/DISABLE AXES – Toggle button which
8.
enables/disables all axes.
RESTART EXPRESS CONTROLLER – This button is
9.
used to restarts the motion control program.
10. EXIT – Click or touch this button to close this screen
and move to other operations.
18
ALS 4.0
P R O D U C T M A N UA L
6
7
8
1
5
4
Figure 30
EN
9
10