Alpine ALS 4.0 Manual De Instrucciones página 39

Step 11 – Move A1 to 90° using the "A1 Move" button on
the Manual Control Screen.
Figure 124
Step 12 – Stop the blade using the "Saw Motor Off"
button on the Manual Control Screen.
Figure 125
Step 13 – Release the L1 & L2 Clamps using the "L1
Clamp Up" and "L2 Clamp Up" buttons on the Manual
Control Screen.
Figure 126
Step 14 – Release the L1 & L2 Pushers using the "L1
Pusher Out" and "L2 Pusher Out" buttons on the Manual
Control Screen.
Figure 127
Step 15 – Using a framing square on the surface of the
board that was against the fence, check the groove as
shown.
If the cut is square, the calibration procedure has been
successfully completed.
!
If the cut is not square, contact Alpine Equipment Customer
Service for proper procedures, failure to follow proper procedures
may result in damage to machine.
39
ALS 4.0
P R O D U C T M A N UA L
Figure 128
WARNING
EN