Semi-Automatic Operation; Setting Up Cuts - Alpine ALS 4.0 Manual De Instrucciones

The SIZE and GRADE buttons will bring up screens when
clicked. Here, the appropriate entries can be chosen.
Within this dialogue box the following can be changed:
• SPEED – Allows the system speed to be adjusted
per stock entry. It is percentage based with 100%
being full speed.
• CHECK ALL – Selects all with a single selection
• CLEAR ALL – Deselects all with a single selection
• EXIT – Exits the dialog
COST can be entered allowing the saw to calculate the
lumber cost per the job pick list. Cost is based on board
feet. The cost information must be manually entered
and updated.
The SAVE button will save all progress.
3.4

Semi-Automatic Operation

Figure 20
Enter the Semi-Automatic Mode by clicking or touching
the button shown in Figure 20 on the Main Screen.
The following screen will appear (Figure 21):
1
5
6 3 4
Figure 21
The default piece for this screen has square cuts on each
end. Choose the ends that most closely match the piece
required. In the example above, the single cut button
has been selected for the left end and the single cut for
the right end. The selections can be changed at any time
as cuts are setup in this mode.
3.4.1
Change the default angles and heights to match the
piece clicking or touching the buttons below the piece
diagram. As these buttons are clicked or touched, a
keypad will appear (Figure 22). Use this keypad to enter
the correct data.
7
2
15
P R O D U C T M A N UA L

Setting up Cuts

Figure 22
Figure 23
EN
ALS 4.0