Alpine ALS 4.0 Manual De Instrucciones página 47

L1 & L2 Clamps: On the back of the saw cabinet,
there are 2 sets of grease blocks, one for the L1 Clamp
bearings, and one for the L2 Clamp bearings. Each set
has 4 fittings (8 total).
Figure 146
T1 Bearings: There are 2 grease fittings at the back of
the head (as shown in the picture on the right) and 2
more at the front (4 total).
Figure 147
Z1 Bearings: There are 2 grease fittings on the bottom
of the head (as shown in the picture on the right) and 2
more on the top (4 total).
Figure 148
Outfeed Queue Conveyor: There are 3 shafts under
the outfeed queue. Remove the guards around the two
farthest from the saw cabinet and grease the bearings
on each side of the shaft. Do not remove the guard plate
the motor is mounted to. These fittings can be accessed
without removing the motor (6 total).
Trash Incline: There are four bearings on the trash
incline—2 on the drive roller at the top of the incline
(only one is shown in the picture on the right) and 2
more on the idler end at the bottom of the incline, just
under the drive end of the trash/small parts conveyor
(4 total).
Trash/Small Parts Conveyor: Similar to the trash
incline, there are four bearings on the trash/small parts
conveyor—2 on the drive roller on the infeed side of the
saw cabinet, and 2 more on the idler end on the outfeed
side, as shown in the picture on the right taken from
behind the machine (4 total).
47
EN
ALS 4.0
P R O D U C T M A N UA L
Figure 149
Figure 150
Figure 151