Check Alignment Of The T/Z Slide & Belt Feeders - Alpine ALS 4.0 Manual De Instrucciones

4.10 Check Alignment of the
T/Z Slide & Belt Feeders
Step 1 – Place a piece of machined lumber that is at
least 7.25" wide across the L1 and L2 belts.
Step 2 – Engage the L1 & L2 Pushers by pressing the
"L1 Pusher In" and "L2 Pusher In" buttons on the Manual
Control Screen.
Figure 114
Step 3 – Engage the L1 & L2 Clamps by pressing the
"L1 Clamp Down" and "L2 Clamp Down" buttons on the
Manual Control Screen.
Figure 115
Step 4 – Move B1 to "0" using the "Move B1" button on
the Manual Control Screen.
Figure 116
Step 5 – Move A1 to "90" using the "Move A1" button on
the Manual Control Screen.
Figure 117
Step 6 – Move T1 to "-2" using the "Move T1" button on
the Manual Control Screen
Figure 118
Step 7 – Move Z1 to "2" using the "Move Z1" button on
the Manual Control Screen.
Step 8 – Start the blade using the "Saw Motor On"
button on the Manual Control Screen.
Step 9 – Manually Jog T1 forward until a groove has
been cut across the full width of the lumber using the
"Jog T1 Fwd" button on the Manual Control Screen.
Step 10 – Move Z1 back to "0.0" using the "Z1 Move"
button on the Manual Control Screen.
38
EN
ALS 4.0
P R O D U C T M A N UA L
Figure 119
Figure 120
Figure 121
Figure 122
Figure 123