Alpine ALS 4.0 Manual De Instrucciones página 35

Step 9 – Jog Z1 down using the "Jog Z1 Down" button
the Manual Control Screen until it cuts about 3/8" into
the board.
Figure 96
Step 10 – Move Z1 back to "0.0" using the "Move Z1"
button on the Manual Control Screen.
Figure 97
Step 11 – Move A1 to 135° using the "Move A1" button
on the Manual Control Screen.
Figure 98
Step 12 – Jog Z1 down using the "Jog Z1 Down" button
the Manual Control Screen until it cuts about 3/8" into
the board.
Figure 99
Step 13 – Move Z1 back to "0.0" using the "Move Z1"
button on the Manual Control Screen.
Figure 100
Step 14 – Stop the blade using the "Saw Motor Off"
button on the Manual Control Screen.
Figure 101
Step 15 – Release the L1 & L2 Clamps using the "L1
Clamp Up" and "L2 Clamp Up" buttons on the Manual
Control Screen.
Step 16 – Release the L1 & L2 Pushers using the "L1
Pusher Out" and "L2 Pusher Out" buttons on the Manual
Control Screen.
Step 17 – Remove the board from the saw and measure
the distance from the back fence side of the lumber
to the middle of the Centerline cut using a framing
square. This dimension should be 1.75" (45mm). If so, it
is calibrated – go to the next section.
1.75" (45mm)
Step 18 – If the Centerline is off, the hard stop on the
back of the T plate will need to be adjusted.
Step 19 – Turn off the blade motor and the conveyor.
Once the saw stops, open the door to the saw cabinet,
and then shut down the computer
Step 20 – Disconnect the electricity and air supply.
Step 21 – Lock and tag out the electrical and air supply
in accordance with OSHA procedures (i.e. OSHA 29 CFR
1910.147).
35
EN
ALS 4.0
P R O D U C T M A N UA L
Figure 102
Figure 103
Direction of Feed
Figure 104